Boot5Zones error: (perl)
Quote:
So i tried to install IO::Scalar again... on commandline i typed: Quote:
Quote:
Quote:
Quote:
Quote:
I get a warning telling me to adjust perl files? after all this I still get the same errors when i run boot5zones Using 59perl and Malignus Wingnut's Setups followed all directions, perl setup didnt go as he said it should, but i thought it was installed after a little work in the command prompt. Boot5Zones= Quote:
LoginServer= Quote:
Quote:
|
Make sure you have nmake.exe in your \perl\bin dir (the link can be found from a search) Also, make sure perl is installed in a path that conforms to 8.3 standards. I remember having problems when I had perl installed in a dir with spaces. When i reinstalled it into another folder it worked fine.
|
Make sure you have nmake.exe in your \perl\bin dir (the link can be found from a search) Also, make sure perl is installed in a path that conforms to 8.3 standards. I remember having problems when I had perl installed in a dir with spaces. When i reinstalled it into another folder it worked fine.
|
NMAKE is in the perl/bin folder
perl is installed to C:/perl I see another thread about these same errors, ill try those suggestions and maybe download a different version of ActivePerl |
The easiest way I found for myself was to download the IO-Stringy-2.109 - just google it.
Than extract the the lib\IO folder into your C:\perl\bin\lib\IO The IO-Stringy file contains some .pm files, including those that are needed for IO::Scalar. At the DOS prompt, just use: perl -MIO::Scalar -e "print 'Installed'" to make sure your ready to go... :) |
with most recent downloads and changing NMAKE to NMAKE.exe works flawlessly
|
All times are GMT -4. The time now is 08:32 PM. |
Powered by vBulletin®, Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.