Confusion about compiling
 

I created an Emu server a while back using the PEQ pack "0.7.0-1110a" and got it working.

I've just tried compiling the source from "http://projecteqemu.googlecode.com/svn/trunk" through the "http://www.eqemulator.net/wiki/wikka.php?wakka=VS2008" walkthrough and I think I did it correctly.

What do I do after I click the "Build/Build Solution" and Visual C++ Express finishes? I looked in the "Build" folder and it has some files, but not nearly as many as those in the eqemu dir I had from the "PEQ pack "0.7.0-1110a"" install.

I don't know if I'm supposed to overwrite old files in my "PEQ pack "0.7.0-1110a"" server with new ones from the build I just did, or if the build I just did is a complete Emu.

Where are the files from my build, and what do I do with them, and if I need to get other files, where do I get them from?

I = extreme n00b.

Then what are you doing trying to run a server.

I am trying to setup an updated server for me and my friends to play. Thank you for asking =).

Try this:

http://www.eqemulator.net/forums/showthread.php?t=28190

If you were able to compile successfully, then you're most of the way there. 99%, even, the hard part's over. What you need to do is be sure to follow the very closing steps of the guide, starting at #8:

Go into those directories and pull the selected files. They will be the files that you move into your EQEmu folder.

Thank you so much! So how does this look:

• Create a folder called "EQEmu"
• Place all the subfolders and files from the *defaults* dir into the "EQEmu" folder,
• Then place into said "EQEmu" folder: Chatserver.exe, EMuShareMem.dll, World.exe, Zone.exe, eqlaunch.exe, mail_opcodes.conf, opcodes.conf, patch_6.2.conf, patch_Anniversary.conf, patch_Live.conf, patch_SoF.conf, patch_Titanium.conf

And then at this point the Emu software is compiled and up to date and then I move on to the rest of the Emu install/creation (database setup and config setting adjustments and etc...)

Does this sound right or have I blundered anything?

I have a working EQEmu server going already, so my method is just to take the different files listed in section 8, add them into a new folder elsewhere, and then select all of them and overwrite my EQEmu directory with those files. I personally skip the EQEmu config files (the .xml ones) so that I don't have to re-do my server configuration each time.

Whatever works for you, though =)