Port forwarding refuses to work
I have a private server that works on Lan but can not remote into it.
I have ports 9000, 7000 -7010, 3306, 5998, 5999 all set in port forwarding. 3306 shows open. 9000 shows open. All others show closed. I have been on the phone with AT&T, they decided that is was a bad modem/ router. Got the new router / modem in today, set it up and same thing. AT&T says they are not blocking any ports. Tried setting the new modem to pass through mode and ran a new router behind it. NO ports show open at all. Something is either wrong or AT&T is blocking though they say they are not. All this started when I switched from DSL to U-verse. DSL my server was accessable outside my local network. Since changingto U-Verse, only local access (been this way for a couple years . The server is running on Windows 10 64 bit I can get on my server from any PC in my local network but not outside. Code:
`<?xml version="1.0"?> Any Ideas? Aardil |
SOLVED
Since my set up is not standard EQemu (I have a very old Heidi Gui interface) On my interface there is a spot to put your local IP, The Ip that was in that spot was not even in the range of availbe addresses for the new router. The server obtained a new address with the new router install but I did not update the IP on the Heidi gui. Also my server was set to private, not public. There were a couple of other minor issues but I think the above is what got it working. Aardil |
All times are GMT -4. The time now is 08:20 PM. |
Powered by vBulletin®, Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.