EQEmulator Forums - akk-stack: New debian 10 VPS, can't log in

I just rolled a 4 vCore / 8 GB / 160 GB SSD NVMe VPS. Clone and make install seemed to go fine.

I ran,

Code:

sudo su



make init-reset-env



make set-vars port-range-high=7030 ip-address=my.vps.ip



make install

I then logged into Occulus, set the server long name and short name, added my worldserver login/pass on loginserver #1, then rebooted.

Code:

make bash



m



start

At this point, using my clean Rof2 client I could see my server in the eqemu login list but was unable to login.

I then went back to "make bash" and ran,

Code:

cd server



./server_start.sh

More zones booted up this time, but still no luck. I'm unable to log in.

Am I missing a piece of the puzzle? This is a fresh server. Do I need to open ports? I was under the impression that docker handled ports