I just ran this on Windows 11 on my new laptop, and it installed with no issues at all. Just FYI.
Code:
[Install] Instructions
[Install] In order to connect your server to the loginserver you must point your eqemu_config.json to your local server similar to the following:
"loginserver1" : {
"account" : "",
"host" : "login.eqemulator.net",
"password" : "",
"port" : "5998",
"legacy": "1"
},
"loginserver2" : {
"account" : "",
"host" : "192.168.197.129",
"password" : "",
"port" : "5998"
},
"localaddress" : "192.168.197.129",
[Install] When done, make sure your EverQuest client points to your loginserver's IP (In this case it would be 192.168.197.129) in the eqhosts.txt file
cannot unlink file for db_update\db_update_manifest.txt: Permission denied at eqemu_server.pl line 1742.
cannot remove directory for db_update: Directory not empty at eqemu_server.pl line 1742.
[Install] Press any key to continue...
Can't open new_server: No such file or directory at eqemu_server.pl line 1746.
[New Server] New server folder install complete
[New Server] Below is your installation info:
[Install] Installation complete...
[Install] Server Info (Save somewhere if needed):
- # For Windows - Do not change these
- mysql_root eqemu
- mysql_eqemu_db_name peq
- mysql_eqemu_user root
- mysql_eqemu_password eqemu
[Install] Windows Utility Scripts:
- t_start_server.bat Starts EQEmu server with 30 dynamic zones, UCS & Queryserv, dynamic zones
- t_start_server_with_loginserver.bat Starts EQEmu server with 30 zones with loginserver
- t_stop_server.bat Stops EQEmu Server (No warning)
- t_database_backup.bat Backs up the Database to backups/ folder - do not run during server is online
- t_server_crash_report.pl Will parse any zone crashes for reporting to developers
[Configure] eqemu_config.json Edit to change server settings and name
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>>> EQEmu Server Main Menu >>>>>>>>>>>>
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
[database] Enter database management menu
[assets] Manage server assets
[new_server] New folder EQEmu/PEQ install - Assumes MySQL/Perl installed
[new_server_with_bots] New folder EQEmu/PEQ install with bots enabled - Assumes MySQL/Perl installed
[setup_bots] Enables bots on server - builds code and database requirements
[conversions] Routines used for conversion of scripts/data
exit