zoning in from nro to oasis
 

I noticed that zoning in to oasis from nro that you do not end up in the area you should (relitive to where you exit nro)


same with east and west commons.

Is there a zone point area or something that i need to add in the database?

Found this after I posted its from an old 06 i think, the post the made it clear for someone but I can't make any sense of it.

I looked through the database last night and can't find the keep position column. Any idea what table its in?

There's no keep position column. I believe they were talking about using the x/y/z columns. If they are that number, it means to keep whatever x/y/z position from one zone to the next.

OK thanks, Ill test this out tonight.

I don't even think PEQ has those zones setup properly quite yet, I mean you'll see a spawn or two, but they aren't working for the most part.

Actually, if you wanted too, you can populate the zones also using EQExtractor and grab the zone points (I think?) you'd have to have a live account though, wireshark and the program from the svn.

Wait, I'm dumb. Are you talking about the newer revamped zones or the older ones?

More than likely you have the wrong map files, etc...

If you do some searching on the forum you will find plenty of information on this. I am guessing you are using a new client than Titanium ? If you have Titanium log in and look around, more than likely you will notice everything works fine with it.

I went to the zone points table there under the appropriate zone name, changed the y,x,z and target y,x,z to 999999 each. I zone directly across but am under the world. I am sure if i mess with the coordinates I can something close to perfect.

You can leave the x/y as 9's and set the actual z if you want.