[Darktanion]

Sorry for this bump but I wanted to leave that other post for noobs going from one eqemu to another.
I figured out what the problem was exaclty. I am learning something on my own thank god hehe.
Basically what is happening to MOST people is they are missunderstanding the tutorials alot. Basically when you source things it will not overwrite any of the existing stuff that is there. Well you can do it without screwups but it will keep giving you duplicate key unless there is something that is not already there then it will show the code of row affected (0). What this error I had above was from is this::::
If you want to load only PEQ_Kunark then just load it and not anything from the velious package. For some reason it will screw up alot of things. Well at least for me from what I have done so far. I would suggest deleting your eq folder and starting from scratch. If you load the velious over the top of your existing DB it should work but when you try to go back to your DR2 it will not run I will gaurantee it wont. The reason for this is you just made it velious capable and now it wants you to upgrade to the DR3 version of eqemu. I found this out the hard way. The error above is because I was using Kunark on the DR3 and that was not working at all....

In short if you use Kunark then you will want to use the eqemu 0.6.0 DR2 version.
If you want to use Velious then you will need to download the 0.6.0 DR3 from Belfedia before he stops the download processing from his site....
If I am way off then I am sorry for this post but I tried to run DR2 after installing the velious and it wouldnt work properly at all. But it ran the DR3 just fine.