View Single Post
  #1  
Old 05-12-2015, 11:10 AM
provocating's Avatar
provocating
Demi-God
 
Join Date: Nov 2007
Posts: 2,175
Default Zones misbehaving

I have two zone processes that start to act up after a few weeks. They will start tacking out the processor at 100% where the other zones are just fine. Since there are plenty of cores I normally do not notice unless I do a top and see them.

Our source has a few changes but nothing that should cause this to happen. I thought originally it was one of our static zones but at this point I know that to not be the case. Mainly what I am looking for here is some ideas on pinpointing which dynamic zone is causing the issue. I looked through the logs and nothing just jumps out at me being an issue.
Reply With Quote