caravelle:
Local IP : Port Global IP : Port Timer Flags Proto Interface
192.168.0.2:9000 *****:9000 0 0x00041 tcp eth0
192.168.0.2:7990 63.228.50.206:7990 0 0x10041 tcp eth0 wan0-
0
-7999 -7999 <-- /em scratches head
192.168.0.2:7990 *****:7990 0 0x02041 *** eth0
192.168.0.2:7991 *****:7991 0 0x02041 *** eth0
192.168.0.2:7992 *****:7992 0 0x02041 *** eth0
192.168.0.2:7993 *****:7993 0 0x02041 *** eth0
192.168.0.2:7994 *****:7994 0 0x02041 *** eth0
192.168.0.2:7995 *****:7995 0 0x02041 *** eth0
192.168.0.2:7996 *****:7996 0 0x02041 *** eth0
192.168.0.2:7997 *****:7997 0 0x02041 *** eth0
192.168.0.2:7998 *****:7998 0 0x02041 *** eth0
192.168.0.2:7999 *****:7999 0 0x02041 *** eth0
10.0.0.2:2066 63.228.50.206:31903 120 0x00046 udp eth0 wan0-
0 <-- /em sings One of these things aint like the other... one of these things aint quite the same.
10.0.0.2:1110 63.228.50.206:31904 86400 0x00046 tcp eth0 wan0-
0
10.0.0.1:23 63.228.50.206:23 86400 0x0004A tcp eth0 wan0-
0
First read the new sticky note on this topic.. as I kinda fine tuned the instructions at the bottom of my story. (main diff is not have ing you try the 7990-7999 attempt).
Second... I read threw this show nat.. Hmm not too bad should still work then BOOM wtf???? 10.0.0.2??? Silly Caravelle, I think you followed my doc a little WAY too close, as I beleive your PC's are on a 10.0.0.0 Network.. not a 192.168.0.0 Network.
What is the IP of the PC that is running your server? (guessing 10.0.0.1 or 10.0.0.2) If this is the case you will need to re-add those NAT entries.. but replace 192.168.0.2 with your eqemu servers IP.
But first you will want to blow away all those bogus entries you just created.
cbos#set nat entry delete inside 192.168.0.2
That should take care of those. And remember... read the sticky version of my doc as I made that small change.
Luck or no luck please still cut/paste your show nat here. Also.. remember your cbos#write mem
|