Followed the guide on:
http://www.eqemulator.org/forums/showthread.php?t=29043
by the word. Now, when I start up the startup.bat, I get:
"EQEmuLoginServer.exe - Application Error:
The application was unable to start correctly (0x000007b). Click OK to close the application."
Everything else works fine, just errors on the login server, and then I get a ton of:
"Could not connect to login server: TCPConnection::Connect(): connect() failed. Error: 10061"
My eqemu_config.xml:
Code:
<?xml version="1.0">
<server>
<world>
<shortname>twinkiefactory</shortname>
<longname>twinkiefactory</longname>
<!-- Only specify these two if you really think you need to. (read: You don't) -->
<address>127.0.0.1</address>
<localaddress>127.0.0.1</localaddress>
<!-- Loginserver information. Defaults shown -->
<loginserver>
<host>192.168.1.47</host>
<port>5998</port>
<account></account>
<password></password>
</loginserver>
<!-- Sets the ip/port for the tcp connections. Both zones and console (if enabled). Defaults are shown -->
<tcp ip="localhost" port="9000" telnet="disable"/>
<!-- Sets the shared key used by zone/launcher to connect to world -->
<key>kiw9083wdfgesiwud</key>
<!-- Enable and set the port for the HTTP service. Defaults are shown -->
<http port="9080" enabled="false" mimefile="mime.types" />
</world>
<database>
<host>localhost</host>
<port>3306</port>
<username>root</username>
<password>eq</password>
<db>peq</db>
</database>
</server>
my eqemulogin:
Code:
Port=5998
DumpPacketsIn=true
DumpPacketsOut=true
Trace=true
DatabaseServerName=localhost
DatabaseCatalogName=PEQLoginDB
DatabaseUserName=root
DatabaseUserPassword=eq
OPCodePathAndFileName=login_opcodes.conf
AllowUnregistered=true
my startup.bat
Code:
@echo off
start EQEmuLoginServer.exe
pause
start world
echo waiting for the world to finish before starting zone...
pause
start eqlaunch zone