colemantis441
11-23-2008, 03:33 AM
Hello everyone.
First of all, thanks for taking time to look at this and sorry in advance if it has already been answered. I've looked around and tried different things, but to no avail.
Whenever I begin the start.bat file, everything loads up perfectly on the second screen and ends with "Loginserver provided <IP address> as world address." Then, I press enter on the "Wait for world to finish loading screen.." After that, on the other screen I receive the following:
[WORLD_LAUNCH] zone: dynamic_01 reported state STARTED (1 starts)
[WORLD_LAUNCH] zone: dynamic_01 reported state STOPPED (1 starts)
It repeats this cycle over and over again and won't continue on to start dynamic_02. I tried editing the start.bat file to read "start eqlaunch.exe zones" as opposed to just having "start eqlaunch.exe zone." Adding an 's' onto 'zone.' This was suggested in another post, but this seemed to create more problems.
Any help would be appreciated!
Thanks
First of all, thanks for taking time to look at this and sorry in advance if it has already been answered. I've looked around and tried different things, but to no avail.
Whenever I begin the start.bat file, everything loads up perfectly on the second screen and ends with "Loginserver provided <IP address> as world address." Then, I press enter on the "Wait for world to finish loading screen.." After that, on the other screen I receive the following:
[WORLD_LAUNCH] zone: dynamic_01 reported state STARTED (1 starts)
[WORLD_LAUNCH] zone: dynamic_01 reported state STOPPED (1 starts)
It repeats this cycle over and over again and won't continue on to start dynamic_02. I tried editing the start.bat file to read "start eqlaunch.exe zones" as opposed to just having "start eqlaunch.exe zone." Adding an 's' onto 'zone.' This was suggested in another post, but this seemed to create more problems.
Any help would be appreciated!
Thanks