Taking level restriction off of gloomingdeep

Randymarsh9 · #1 01-24-2009, 05:39 PM

I am using gloomingdeep as a hub zone for my server, but I can't seem to take the level restriction off of it. I used navicat to change the level from 10 to 80, but people over 10 still cannot zone in.

Sakrateri · #2 01-24-2009, 11:32 PM

setting it to 80 now means only 80 or higher can zone in, set it to 0

Randymarsh9 · #3 01-25-2009, 02:33 AM

I tried setting it to 0, but when I tried to zone a character in, it still said that he was too high of a level at level 21.

Randymarsh9 · #4 01-25-2009, 08:25 PM

Anyone have any solutions for this? is there somewhere else I will need to change the value instead of just rules_values and variables?

leslamarch · #5 01-25-2009, 08:49 PM

Misread post

Randymarsh9 · #6 01-26-2009, 12:49 PM

Ok, are there any suggestions for this? No matter what I am setting the max level for tutorial to in my rules and variables, it still will say a level 20 is too high to enter.

Angelox · #7 01-26-2009, 01:12 PM

Up above in these forums, theres a 'search' option in the pull-down menus - I did a search for 'Tutorialb' and 'level', came up with this.

Randymarsh9 · #8 01-26-2009, 01:38 PM

I actually already read that before I posted. That's where I learned what rule it was. I changed it from 10 to 80 in the rules, it didn't work, then to 0, then 255. It didn't allow a level 20 in for any of those levels. Then I tried replace into variables (varname,value) values ('World:MaxLevelForTutorial','0') in mysql and it didn't work. I also tried using #rules setdb World:MaxLevelForTutorial 0,80,255 while ingame and it still didn't help. I restarted my server after everything I tried and I am stumped as to what else I can do

**Derision** · #9 01-26-2009, 01:42 PM

Are you getting a message or is the Enter Tutorial button just not highlighted ? If you get a message, what does it say (word for word) ?

Angelox · #10 01-26-2009, 01:58 PM

Also, when you boot up the server, do you see the message for "World:MaxLevelForTutorial" being set to 0?

Randymarsh9 · #11 01-26-2009, 02:03 PM

Yes it says that it is

Randymarsh9 · #12 01-26-2009, 02:07 PM

And when I try to zone my character in, it says You are too high in level to be in this zone.

Angelox · #13 01-26-2009, 02:08 PM

What version source (or executables) and database do you have?

Randymarsh9 · #14 01-26-2009, 02:10 PM

Do you mean revision 271

Angelox · #15 01-26-2009, 02:24 PM

Yea, just trying to figure out why it would do that - there's also a table (I'm at work, so I can't tell you the exact name) - it is a Zone table and will bump you if you have a higher level set on it. Also the NPC that sends you there will bump you too.
Also, Derision asked"Are you getting a message or is the Enter Tutorial button just not highlighted ? If you get a message, what does it say (word for word) ?"