Local Server Issues

[Uleat]

The first thing is that your eqhost should be set to 5998 for a titanium client. I noticed that you are using port forwarding. Is this a public or private setup? Your configuration is dependent upon what setup ou want to use.

Is it:

A private network-based setup with a local login server?

A private network-based setup with a remote login server (i.e., www.eqemulator.net)?

A single computer connected to an ISP IP address?

etc...?


If you're using a local login server scheme (and not the minilogin), check out my post on solo computer setup here:

http://www.eqemulator.org/forums/showthread.php?t=35222

(I don't know how to make it focus on my post, but it's down near the bottom on the first page.)

Then, if you're on a private network, make the changes for a lan setup (changing 127.0.0.1 to 192.168.xxx.xxx where appropriate..but not the database.) This same setup will work if your hosting a public server as well, as long as your use the port forwarding. If it's a private server, clear out the port forwarding or you could get unwanted outside traffic.

(It could be a typo, but make sure your port forwarding 'range' is 7000 to 7100 and not just 7000 to 7001.)

[jshows1]

I appreciate the response, Uleat. To answer your question, I'm using a single computer to login to a server on the same pc.

I don't really care to have it setup as an online server, I just happened to come across Huppy's post here:

http://www.eqemulator.org/forums/showthread.php?t=32980

It was very thorough and seemed to work when I setup the server portion.

Back to your info, I'm looking at the post you gave in your link. Since I want to run a solo server from the same machine, should I follow that information you posted in the other post?

Also, I'm using rev2133. Should I not be using that one? If not, should I source in the db that you mentioned in the other post?