question on rev2506 and no zone server error

EODQozjay · #1 08-21-2013, 12:05 PM

Im reading up on .bat wiki to find out where I went wrong. Im sure Ive omitted something I need, thank you lerxst2112. The current window eqemu wiki setup didnt cover the setup of the start. bat /shared. I'll post the results of the new start.bat when its rebuilt.

One other problem Ive been having is getting others to connect to my server. Ive set up my router to allow the ports UDP 7000 to 7100 and UDP 9000 for the IP for the server pc using ipconfig from prompt and used the IPv4 address. Then I set up my eqemu_config.xml and only edited the fields listed in the Wiki WindowsServerSetupGuide
Using a Motorola SB Gateway NAPT mode disabled and using Netgear router. Server PC is running wireless on that router. Win7 64bit Kaspersky 3.0 AV

<chatserver>
<host>(edited this to IPv4 address)</host>
<port>7778</port>
</chatserver>

and


<mailserver>
<host>(edited this to IPv4 address)</host>
<port>7778</port>
</mailserver>
....are the only values I have edited for connection

rencro:
That will be my next proj to figure with rev I am using. I can see common problems logged in to the server so I know which ever rev Im using needs updated, but I did build my db from a rev labeled 2506. I think Im missing a column after reading the readme file... but that will be my next step after fixing start.bat and connection.

Thank you for the help

wolfwalkereci · #2 08-21-2013, 01:08 PM

Quote:

Originally Posted by EODQozjay

I did build my db from a rev labeled 2506.

As was said before if you are starting with someone else's 2506 DB you are going to have some minor problems with it.
Basically it sounds like you took a 2506 DB and a new compile of the source and you wonder why stuff is not working.

At least you seem to understand and are asking the right questions to get it fixed but seriously wth does that DB have that you need so bad? I would dump that one and just use the current daily from PEQ.

rencro · #3 08-21-2013, 01:55 PM

I'm assuming you are using the harbinger db just released, that is mentioned was set at 2506, but in any case, if its a 2506 db and you want to run this db with "new" source code, then the db would need to be updated to the "new" code you built, unfortunately git does not use rev ##, but dates, but the same principle applies, all the required "date" git sql's would need to be sourced into your 2506 db. Then there is the issue of the "optional" 2380_mercs* sql's and mercs.sql, these were optional, but after git now are "required" and you may run into an issue when you run the new git required sqls(primary key blah blah blah)...

Or you could just build the last svn source code release 2509 and be done(no lua for you)....But if it is harbingers, look up that thread for a fix to a crash or SLOW LOAD TIMES from null values in the db...

EODQozjay · #4 08-21-2013, 02:27 PM

Quote:

Originally Posted by wolfwalkereci

As was said before ....

my heart is not set on that db. I was just trying to make a kunark base ver that was stable with no tweaks ie. xp quests nps. When I was familiar the workings with everything up to that point I was going to build a Velious Server. Bomb techs tend to start in the middle and work both ways with something they fully know, plus thats the excitement of learning something new.

I will set it up to use the dailey from PEQ.