Zone.exe compile errors

[Uleat]

If you just select 'Build' when compiling updated source code, the external links within the obj files may still point to old, and now invalid, entry points.

Sometimes, there are new files added to the project that require cmake to be re-run as well..otherwise, your old solution will not know where to find
these new files..or that they even exist...

Try 'clean solution,' then 'build solution' or use 'rebuild solution' to force a complete compile (the former is preferred.)


If all else fails, you can always try to delete your 'build' directory and re-run cmake to ensure that all of the old references are gone.

[Mortow]

Ok, I deleted the build directory and re-ran c-make (which I do every time I pull new source code because I do not know when it is required and when its not) but still got the same three errors. I pulled the source again since Mackal had made a change in the last hour but this produced a bunch of errors. I tried the Clean Solution and it says it succeeded on all 13 but it did it in a matter of about 3 seconds. I then did build solution but came up with the same three errors.