That technique works. It's a little finicky, but not hard to grasp.
In order to allow an accurate zone transfer, the axis or plane of the zone line crossed, must share the same x or y coordinate, or pretty close. The "keep" function, 999999, only needs one sharing coordinate.
This means "keep" can only be used on a maximum of half the zone lines, although, probably much less due to zone coords typically ranging from 0,0 and the irregular formation of all the zones. I haven't, nor will I likely analyze the coords of all zones to apply use of "keep" in the most effective way.
As this applies to me, I still have conflicts, specifically with nro to freporte, and probably others.
Did I understand this right? If so, what can I do to rectify the other zone lines?
* Do the map files play a role in this? I have both new and old east freeport map files. Many of the map files show up with a red ! over the icon which I assume means there is some sort of conflict.
Thanks Shendare.
* Thanks Kingly!
|
Hybrid Mode
