Error 2 at SQL CMD?

[Havocide]

Well it turns out that it was a directory issue that I corrected and it compiled ok. I am on the finalizing stages of the guide where it says " You will see a 2 windows come up, one will say

Wait for World to Finish LoadingPress Enter to Continue


And the other will say several lines of code, give it a second and it should stop, with the final two lines reading

[DEBUG] [WORLD__LS] Connected to Loginserver: eqemulator.net:5998
[DEBUG] [WORLD__LS] Loginserver provided YOUREXTERNALIP as world address


It opens up the first window and closes too fast for me to read and leaves up the "Wait for World to Finish LoadingPress Enter to Continue" . I click continue and it opens up the 3rd bow which displays nothing at all no matter how long i wait. Not sure where to start looking for the problem other than retracing steps.

[Derision]

Originally Posted by Havocide

It opens up the first window and closes too fast for me to read

This sounds like world.exe has a problem. What I would do would be open up a command prompt/ DOS window, then change directory to where you have world.exe installed and run it from there, e.g.

C:> cd \EQEmu (assuming this is where you have world.exe)
C:\EQEMU> world

This should display any error messages form World without closing the window. Then copy/paste the output here to allow further diagnosis.

[Havocide]

C:> cd \EQEmu (assuming this is where you have world.exe)
C:\EQEMU> world


This is what comes up.

[techguy84]

Did you set up a account with the name "eq" in mysql. I normally just use the root account at first until I can get things running right, then I vary with other features and settings. Try your root acount and see how it goes.

[Havocide]

Originally Posted by techguy84

Did you set up a account with the name "eq" in mysql. I normally just use the root account at first until I can get things running right, then I vary with other features and settings. Try your root acount and see how it goes.

Used "root" on both as a basic setup.

[techguy84]

Originally Posted by Havocide

Used "root" on both as a basic setup.

Well, your world window says that your using "eq" as the database username. Check your eqemu_config.xml file under the Database section and change eq to root.

[Havocide]

Originally Posted by techguy84

Well, your world window says that your using "eq" as the database username. Check your eqemu_config.xml file under the Database section and change eq to root.

Ya I seen that, thats very odd. here is my config.xml



does this look correct ?