But it WORKS on my test servers... Did you load up the Web Templates in EQEMU and look at what ports it was loading the zones up in and then forward your router accordingly?
It takes some time for ALL of the zones to get fully loaded, so be patient for them all to appear. This is what I did and also found that I had to forward the UDP ports with the same ranges, why I don't know. I am using an RV082 LinkSys router and until I did, I still could not connect to a zone on the ZONE only server.
After I got it working, I shut it all down and restarted it and the port forwarding held true and I was able to access all of the zones I had loaded up.
I am beginning to think that you don't need to set ports in the 7000 range on the Zone only server because they are used by WORLD , not zone. It says it right there in the config file.
ie:<!-- Sets port range for world to use to auto configure zones -->
__________________
Random Segments of Code....
Last edited by Aramid; 04-21-2008 at 06:16 AM..
|
Threaded Mode
