Sure, here is the guide I use. There are a few tricks to get it to work but its the smoothest one I can find!
http://eqemulator.org/forums/showthread.php?t=32980
It will work when you iron out the kinks, I used it two days ago to re build my server after a hard crash.
The largest problems I can remember where doing the database build, if you follow the guide to the letter, the build will have 2 suceeded and 3 fails. To fix these, one of the errors is perl512.lib. Find that file and change it to perl510.lib (just re name it) Doing this will fix 2 errors.
If I did not make it super clear, here is the forum page for the information to fix it =)
http://www.eqemulator.org/forums/sho...hlight=install
The last next issue was sourcing the database, this link is my post about the issue and how I resolved it.
http://eqemulator.org/forums/showthread.php?t=34017 (The 5th post will guide you through the final problem, follow the link)
Anyway, when you go to source the DB **DO NOT TYPE IN "source peqdb_revXXX.sql;** as the guide says.
Type this instead.. source db_dump.sql;
After doing this, your server REV is equal to 1900. Now the guide will teach you how to manually source in the rest of the updates.
When you go to source in 1711_account_restricted_aa.sql it will not load it properly, so. Open it up with wordpad or whatever you have, and delete the entire first line, and save. then re source it.
After that is all said and done, continue following the guide... to the letter! Cant stress it enough, I made allot of mistakes my first few times.
But, every problem that should happen I think I have covered.
I hope this helps!
GL and HF!
Apoc.
Threaded Mode
