When I followed the installing instructions on page one, Perl installed without ever having a chance to enter the commands at the prompt as told to in the instructions.
Talking about this part..
3. Now install the Perl 5.10 (1007). Type yes to everything BUT There will be
one question that has C:\Perl in it. That question requires you to enter
that path as the answer. So just type c:\perl (YOU HAVE TO REBOOT FOR NEXT STEP)
After you rebooted, open command prompt and type the following (one at a time and
wait for it to finish):
ppm install DBI
ppm install IO-stringy
Once I entered in C:\Perl it again just had me keep typing yes, then when it was done installing the command prompt closed. Did I miss something?
|
Threaded Mode
