Ok..
I have a solution, but something is still amiss to me.
When I simply used moveto(x,y,z,90,1) with no grids, the npcs routed to the location and stayed there (the 1 for save guard spot worked). But, I didn't like this, as the mobs ran trough walls, etc.
So, I created a grid that all of them can use.
When I put them on the grid from the beginning, I simpy let the grid take them to where I wanted. Then, if I used an WAYPOINT event to do your suggestion $npc->saveguardpoint followed by a pause, that worked.
So.... I took it one further. Once they all recached the end point (which since I was now using 1 grid was the exact same spot.. I did the move(x,y,z,90,1) with the locs I orininally wanted. With no grid, back i my 1st example, that 1 at the end saved their guard spot and they did not move. Now, on a grid, it did not. Is that a bug?
I ended up doing the following, so I'm all set, but the above seemed maybe like a bug so I wanted to mention it.
- tookthem back off the grid in the db.
- Used start(grid) on them in their spawn code.
- used move(x,y,z,90,1) in their arrive code
- then added a stop();
That worked.
|
Hybrid Mode
